Connections

How to connect components in my editor.

To make connections you simply have to click on a hole to start making one, and click on another hole to complete it.
While making it, the path the connection takes will first go vertical, and then horizontal, or the other way around, depending on where your mouse is. To control this you have to move your mouse closest to the side you want the connection on.
Like this:



A few handy tricks:

• If you want to make a connection to a component, but the component is in the way, hold ctrl or cmd and then make the connection.


• If you want to remove a connection, holt alt and trace over the connection.
  Like this:
  
  


• If you want to stop making a connection, press esc.